The water meter is typically located near the curb in front of your property, with a rectangular concrete or black plastic lid. (ESP)
1. Do the one-hour test
Read all of the numbers on the water meter straight across from left to right and write those numbers down. Do not use any water for one hour. After the hour has passed, read all of the numbers on the meter again. If the numbers have changed, it means that water flowed through the meter and into property. It is the owner’s responsibility to identify water use within their property. Possibilities include dripping faucets, and toilets constantly re-filling. Any fixtures which drain into the City sanitary sewer system may use water without it showing up as an outward leak or wet spot.
2. Do the all day (or all night) test
Turn off the ice maker and read the meter before you leave for the day (or for the night). Take another meter reading when you return. If the numbers on the meter changed, something (or someone) used water on your property.
3. Do the before-and-after test on the sprinkler system.
Read all of the numbers on the water meter that services the sprinkler system, and write those numbers down. Operate your lawn sprinkler system for the same amount of time and use the same number of stations you normally do. Visually inspect all stations checking for broken sprinkler heads or other problems at the surface. When the system cycle has totally finished, take another full meter reading. Subtract the first reading from the second reading to calculate the amount of water used. If there are any breaks or loose fittings underground, the water loss will only show up when you run the full cycle of the system. Because water naturally flows in a path of least resistance and gravity pulls it down, many underground leaks do not appear on the surface of the ground. Also, you should check the settings of the electronic timer, as electrical storms and power outages can affect or change your time settings.
4. Do the food coloring test
Remove the cover from the tank of the toilet and put enough food coloring in the clear water of the toilet tank to darken the color of the water. Do not flush the toilet for 30 minutes. If the darkened water from the tank moves into the toilet bowl, it indicates that the flapper on the bottom of the toilet tank may need to be replaced. A worn or misaligned flapper can cause a toilet to ‘run’ constantly, which can be heard by listening closely near the bottom edge of the tank. It also causes the tank to refill automatically every 5 to 20 minutes.
5. Do the water level test
Remove the cover from the tank of the toilet and look at the long open pipe standing up in the middle of the tank, called the overflow tube. The top of the water level should be about 2 inches below the top edge of this overflow tube. If the water level is up to the top of the overflow tube, water silently slips over the edge of the tube and right on down the sewer. This will cause the toilet to constantly refill with new water. If you find that the water level is too high, the float mechanism in the tank may need to be adjusted or replaced.
|NOTE: It is the property owner’s responsibility to locate and repair all sources of lost water consumption (leaks) on the property. After all repairs have been completed, watch your next two meter readings and billing periods. If the lost consumption (leak) caused your normal water consumption for that yearly time period to double, call us at 817-275-5931 to ask about a possible partial adjustment on your bill. Also, if the lost consumption occurred during the Average Winter Consumption Period, please contact us at 817-275-5931 or at firstname.lastname@example.org to discuss a possible adjustment to your maximum sewer.|